For South American users, please change the mode to “11b only”. Press for over 10 seconds to restore factory settings. What should be the setting for this, our setup from our source AP was IP authenticated. Trademarks All products, company, brand names are trademarks or registered trademarks of their respective companies. Copyright The contents of this publication may not be reproduced in any part or as a whole, stored, transcribed in an information retrieval system, translated into any language, or transmitted in any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without the prior written permission. If the list contains no entries with this function being enabled, then no clients will be able to access this Access Point.

Uploader: Gardar
Date Added: 12 August 2013
File Size: 21.9 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 32768
Price: Free* [*Free Regsitration Required]

In addition, 5-level TX power adjustment let you match different antennas for law compliance. This will need port 80 by default for Virtual Server Settings. Product Size L x W x H mm. When my AP is installed in an outdoor wl-54460ap with a lot of 2.

By the default, the WAN ping is disabled.

Page 53 select a level to make sure that the output power measured at the antenna end will not exceed the legal limit in your country. Choose the network you want to connect and click on ajrlive “connect” box. This is to configure WLAP be managed from internet.


The relationship between the percent and dBm are as below: When firmwxre enable this function, the wireless clients will not be able to see each other. The South American firmware is for use in South Akrlive only, please do not use it in other region. When you enable this function, the wireless clients will not be able to see each other.

Please check your e-mail address and try again. List system all log information. How can I extend the distance using extra AP? Do not release the reset button until the “Status” LED goes off. Provide SSID for wireless client survey and connection.

Page 58 Interface Control Settings: Before you start, please check the following area to see which client MACs are supported. How to configure APv2 x 3 to work in point to multipoint mode? If set channel manually, just select the channel you want to specify.

However, if there are more than one wireless network in your area or you want to change to AdHoc mode. Enter the watch dog host ip address.

System Recovery – Air Live WLAP User Manual [Page 70]

Enter the information provided by your system manager. Please change the wireless channel on your AP or Wireless Router. Bridge loop could cause connection fail or broadcast storm. It will also confirm the requestor station that the Access Point has reserved it for the time-frame of the requested transmission.


Security MAC address filtering Firmdare.

Cards communicate directly with each other. For example, you can have your own web server at home and provide access on internet.

Screenshots – Airlive – WLAP V2 (Airlive Firmware) | ™

Unplug the power of WLAP. Sale and delivery by:.

In other words, this device will not be visible by any wireless station. The watchdog functions works by using the Firmdare command. Then check the remote management, please change the port number to “80”. The login screen prompts immediately once you finish setting the account and password. Page 32 To configure the access control, please refer to Section 3.